TeamCapri
Tech, Repairs, Upgrades => Aftermarket => Topic started by: Dillon on July 29, 2008, 01:48:00 PM
-
Looking to replace the shaft on the manual shifter with something angled backwards. Hopefully making it easier to reach and allow for the cupholder insert. Any leads?
Thanks
-
It would be a few hours worth of work to remove the shifter and cut/weld or just bend it in a vise in two areas to bring it closer to your specification...
If you are asking about aftermarket then there is an adjustable short throw shifter available somewhere for the 323, I think from Corksport. I dont know if it will achieve what you are after though.
I would suggest replacing the shifter bushings while you are in there regardless.
-
Thanks for the reply. Does anyone have pictures of the shifter assembly with the both and console off?
Thanks :cool:
-
my boot and console are off. i can do this.
-
Cool. Thanks!