Tech, Repairs, Upgrades > Capri N/A 89-94
ARP Head Studs Mazda Miata 1.6
Vanishing Point:
Will these work on my 1992 NA Capri ?
https://www.pegasusautoracing.com/productdetails.asp?RecID=9125
mitch1204:
Hard to tell when they don't give the dimensions. They are about 5" long. I would be leery over a stud since they are a bolt. Notice the stud is skinnier in the middle where as the bolt is as wide as the threads.
I wonder why they include lubricant as it will change the real torque value if you use it.
I had success reusing my old bolts. Maintain bolt orientation and go to max torque.
I started a thread with the same questions. I special ordered some from AAP and they were too short. After a dead end search and someone else explaining you can get away with reusing the old ones I gave it a try. So far about 500 miles and no problems. I'll torque in about another 500 miles just to be sure.
Sceeter:
They send the lube to put on the treads to get the true torque, any friction throws the torque numbers off.
Rocketman:
Yes the ARP head studs for the 1.6 Miata will work, it's exactly the same engine block & head
Vanishing Point:
Thank you for all of your answers, I think I will order the set.
Navigation
[0] Message Index
[#] Next page
Go to full version